Hassle-Free Boiler Repair and Replacement in Edmonton

Here are some common problems you might have with hot water and steam boilers. While you may be able to handle a few of these issues yourself, you may need a specialist from Enercare McKinley for more complicated heat repair or a nasty boiler breakdown.

• Thermostat isn’t accurate. Check that it’s turned to “on” and the proper settings. Otherwise, your thermostat may need to be replaced.
• No heat. Failed parts, thermostat problems or low water levels could be causing the problem.
• Leaking or dripping. Sometimes caused by a spent internal part, worn-out seal or deterioration.
• Banging, whistling or gurgling sounds. Air in the system, low water pressure or looming part failure can create these noises.
• Rumbling or kettling noise. Reduced water flow caused by lime and sludge accumulation in the heat exchanger. This causes water to overheat and boil.
• Pilot light is out. Caused by a broken thermocouple, draft or built-up deposit. Natural gas could also be shut off.
• Pressure is too low. Water could be leaking, or a pressure valve may need to be changed. Can also be caused by radiators that have been bled recently.
• Condensate pipe is frozen. This pipe runs outside, so there is a threat of freezing. De-ice it by pouring warm water over it.
• Radiators aren’t getting hot. Caused by sludge or air buildup in the system.
• Boiler keeps turning itself off. Could be caused by a couple of issues: low water pressure, thermostat issue, closed valve causing low water flow, air or pump not circulating water properly.

Not scheduling routine tune-ups can often lead to boiler breakdowns. Enercare McKinley can help you choose a plan that could help you avoid expensive service calls—and may enhance your equipment’s efficiency.